This module can be used to determine paths and to calculate speeds at the same time. The ultrasonic transducer rods are connected directly to the RS422 interface. Communication to the transducer rod takes place using start/stop signals. With the DPI/IP protocol, it is also possible, for example, to read operational properties directly from the transducer. During service (when a transducer is being exchanged) the machine can be started again quickly without additional configuration work. The module is designed for connecting 2 transducer rods with a total of up to 4 paths. That means, for example, that 2 ultrasonic transducers with 2 magnets each or one with 4 magnets can be used. The combination 3/1 is also possible. The module provides 24 VDC as an external supply for the sensor.

The post B&R X20cDC2190 appeared first on CentralXL | Industrial Marketplace.

This module is a multifunctional counter module. It can be connected to one SSI encoder, one ABR encoder, two AB encoders or four event counters. Two outputs are available for pulse width modulation. The functions can also be mixed.

The post B&R X20cDC2395 appeared first on CentralXL | Industrial Marketplace.

The module is equipped with 1 input for an ABR incremental encoder with 24 V encoder signal.

The post B&R X20cDC1396 appeared first on CentralXL | Industrial Marketplace.

The module is equipped with 1 input for an ABR incremental encoder with 5 V encoder signal.

The post B&R X20cDC1196 appeared first on CentralXL | Industrial Marketplace.

This module is equipped with one input for SSI absolute encoders with 5 V encoder signal.

The post B&R X20cDC1198 appeared first on CentralXL | Industrial Marketplace.